6
4. OPERATION
4.1 Preparing For Use
4.1.1 Safety Belt
Adjusting length of seat belt
Identify the require length of the belt. (Figure 4.1)
Push the two part of belt through buckle to make the belt longer or shorter.
(Figure 4.2)
Pull the two part of belt tight. (Figure 4.3)
Push buckle up to the plastic clip so that the belt can not slip out of position.
Please check that there is no gap between the clip and buckle. (Figure 4.4)
SUGGESTION:
We recommend that the belt is fitted quite tightly around the pelvis. Please
tighten until you can just get your fingers between user and seat belt. Please
check that the belt is fastened correctly as recommended. If this is not possible
please consult your supplier.
Figure 4.1
Figure 4.2
Figure 4.3
Figure 4.4
How to operate it:
When you sit on the wheelchair, fasten the safety belt. (Figure 4.5, Figure
4.6)
Adjust the belt and make it fit your body for comfort and security.
When you don
’t use it, please fasten the belt to avoid the belt
dropping into
rear wheels during motion.
Figure 4.7
Summary of Contents for KM-AA20 Series
Page 1: ...User manual KM AA20 Series...
