Further informations on:
www.karmaitaliana.it
5
4
Connections
Before arranging any connection, make sure that the plug is
disconnected from the mains. All connections should be
made with the device off.
Mount the light on a stand thanks to the specific bracket (1) and adjust the
tilt as you prefer . The knob (10) allows to fasten it on the desired position.
If you install the fixture in a public location or for more safety, you can use a
safety sling (KARM mod. SAFE 3MM) to fasten it to the stands. In this case
use the safety ring (6) on the back of the product
If you mean to use the device in a DMX light installation, connect the input
and output cables to the DMX IN / OUT sockets (4-5)
Connect the power cable to the fixture’s socket (8) and then to the 230V
mains. If you want to connect other light effects in daisy chain you can use
the specific socket (9). Don’t conncet more than 5 devices together. If
necessary connect the device to the ground by using the connector (3)
Once completed these steps you are ready to use your light effect.
This product can produce two types of effect: lighting rays (2) and strobo
effect (3). Be careful to position it correctly in order to obtain the best result,
avoiding to cover the lenses (2).
It can also be used in different modes:
- Auto mode
- Sound activated mode
- Master / slave mode
- Through infrared remote control
- DMX mode
In the following pages the above modes will be analyzed in detail.
