Installation Instructions – 40649TL
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 8
Step 7 – Installing Partition to Floor
Place assembled partition with wings into van
with the flanged side of partition facing to the
rear and wings bent towards the front.
Push the partition firm against the passenger
side “B” pillar.
Align holes in passenger side wing with
previously installed handle mount.
On the driver’s side, the holes in the outside
edge of the wing should line up with three
existing holes on the side of the van.
Holding the partition in place, use a straight
edge to ensure the bottom of the partition is
straight and square with van.
Be sure this is the desired location to install the
partition.
Mark all holes and slots along floor.
Remove partition with wings.
Based upon lack of obstructions and ease of installation, determine which four locations on each partition
panel to drill into floor.
DO NOT drill beyond depth of
floor. Always check that each
location is clear of wires, fuel tanks
and lines, brake lines and other
important vehicle functionality
items prior to drilling and installing
any product.
Use a drill stop to avoid
unnecessary damage.
Drill hole at each marked location using
25/64” drill bit and appropriate sized drill-bit
stop collar. If 25/64” drill bit is not available, a
3/8” drill bit can be used, although it may be
necessary to tap in the plus nuts.
Insert a 1/4” x 2-1/4” hex head bolt through a 1/4” washer and the plus nut installation tool, and then
screw the bolt into plus nut. Knurled end of plus nut tool must be directed away from bolt head and
contacting plus nut.
Insert and press plus nut, with tool still attached, into hole.