TECHNICAL REFERENCE AND USER’S GUIDE
REV A
GSM GATEWAY
1. Location of the gateway on the wall is determined through the mounting template
and screw spots are marked.
2. The anchor plugs are inserted into the marked spots. (Figure-8.a)
3. Screws are driven so as 7-mm section of their heads will extend out of the wall
(Figure-8.b) (Height of the screw heads could be checked with the edge of the
mounting
template.)
4. The upper screw will be held corresponding to the upper screw slot at the back of
the module and hanged by pulling the module downwards (Figure-9). In the
meantime lower edge of the back cover is risen up so that the other screw would not
prevent the motion of the box.
11
Figurel-9
12
5. When the upper screw has come to the highest point, the lower screw is attached to
its slot by turning the lower cover slightly to the right (Figure-10).
Figure-10
6. Perpendicularity of the module according to the floor is adjusted by sliding the
lower cover in the right-left direction and then the gateway is fixed to the wall by
tightening the lower screw (Figure-10).
7. Cover of the module is replaced after the SIM cards have been placed and
connections of the electric installation and peripheral units have been made.
The PS03 power adaptor has been designed so as to be mounted on the wall, between
the module and the outlet. The electric plug extending out of the adaptor is plugged in an
outlet whose output voltage would not be affected by environmental factors. The module
connection is made by plugging the jack at the end of the power connection cable coming
out of the other side into the POWER input on the module.
Lengths of cables should also be taken into consideration while mounting the adaptor on
the wall. Length of the cable between the adaptor and the module is 50 cm. and length
of the cable between the adaptor and the outlet is 200cm.
The adaptor is mounted 25 cm. away from the module, in the lower left direction.
After inserting anchor plug and the screw, which are within the adaptor box, in the wall
at appropriate distance, the adaptor is hanged on that screw.
PS03 POWER ADAPTOR CONNECTION
Figurel-8
