DS200 User’s Guide
DS200 User’s Guide
DS200 User’s Guide
DS200 User’s Guide
V003. 09.09.2002
C-14
H
Lift the handset.
E
Make the conversation.
Deactivation:
Deactivation:
Deactivation:
Deactivation:
H
Lift the handset and hear the internal dial tone.
78
Dial 78.
G
Replace the handset.
Notes:
Notes:
Notes:
Notes:
1. The redial count for the Auto-dialer is determined through programming (It is 15 by
factory default). The system waits for 15 seconds between two consecutive dials.
2. If the system fails to connect the line after it has dialed the number for determined times
(in the range 1..16), then the call is cancelled.
3. The dial tone shifts to a dual-tone signal for the extension who has activated the Auto-
dialer.
4. The calls coming through the Auto-dialer ring in a distinct cadence at the extension’s
phone.
5. You are warned through ear by short beeps, if your phone is busy during the connection.
In that case, you should either terminate your conversation as soon as possible, or park
your current call and hang up. Then you can answer the recall connected by the Auto-
dialer when your phone rings.
Line Flash (#60):
Line Flash (#60):
Line Flash (#60):
Line Flash (#60):
This service provides you with hook flash facility during a line call. It is useful for the cases
described below:
•
If CO supports some services that require hook flash action, for the cases when such
services are exploited,
•
If two exchanges have been connected to each other by extensions and lines, for the
cases when hook flash action is required on the opposite exchange,
•
If another line access is needed immediately after the termination of a line call.