15
used as an indication of link quality.
Link Quality
A Calculation of RSSI, signal and noise
level to indicate the quality of the communication
link in percentage.
Channel
The channel used by the wireless interface.
Signal Level
A -70 ~ -50dBm signal level is
recommended for a good connection. Too low a
signal, the wireless link between AP and AC cannot
be established. Too high a signal level, the power
amplifier at the receiver might be forced to operate
in saturation region and distorts the signal
waveform.
In order to help user’s reading of the changes,
system also provide a graphic interface to trace the
items’ changes. Click the Graphic Display button on
the top left of the page, graphic mode will show on
your browser.
Status > Connecting Nodes Information
All the connecting clients’ MAC address will be
display in Connecting Nodes Information, including
signal and data rate. The result shows information
only when WLAN was configured as Access Point
mode.
Graphic display is also available for observing the
changes.
Status > Connecting AP Information
In the “Connecting AP Information” page, RSSI, Rx
rate, Tx rate and etc. are provided for verification of
wireless link status.
Graphic display is also available for observing the
changes.
