KARE design Tavola Office, Assembly And Operating Instruction

Page: 33 / 37

4.1.3 Simple memory
This handset has an editable memory for high and low (stand and sit) position. It could
also be used to avoid collision with i.e. a cabinet or pedestal. When a memory position is
set the desk will stop when the memory position is reached. To drive the desk outside the
memory position press the up or down button for a minimum of 5 seconds.
How to set memory/end positions:
1. Drive your desk to the level you want to store.
2. Press both buttons 3 times (0,5-1 second between each pressing).
3. Then press
”up” or ”down” to set the position (0,5-1 second).
4. Do the same procedure for your second store.
To clear memory positions perform a reset as described in section 4.2.
Set
”Upper limit”
Set
”Lower limit”
Above
”Upper limit”
Below
”Lower limit”
>5 sec >5 sec