Kärcher WV 2, Original Instructions Manual

Page: 13 / 164

– 7

Turn off the appliance.
Illustration

Unlock the suction nozzle first and
remove it from the separator, then
unlock the separator and remove it,
too.

Clean the separator and the suction
nozzle under running water (not
dishwasher safe).
Illustration
Caution : The basic appliance
contains electrical components.
Do not clean this under running
water!

Remove the wastewater tank and
pull out the closure.

Empty the wastewater tank and
rinse it with water. Close the tank
again.

Remove the wiping cover from the
spray bottle and rinse it under run-
ning water. The wiping cover can
also be washed in the washing ma-
chine at a temperature of up to
60°C (without the use of fabric sof-
teners).

Let the cleaned appliance dry prior
to assembly.

Charge the battery.

Store the appliance upright in a dry
room.

Refill detergent.

Pump mechanism in spray botte
defective, contact dealer.
Check the charge/operations display:

No signal or slowly blinking signal:
Charge the battery.

With a rapidly blinking signal: In-
form your dealer.

Clean the pull-off lip.

Reverse the used pull-off lip :
Pull the silicone squeegee to the
side. Wet the squeegee in the area
of the curve with water or detergent.
Slide the silicone squeegee back in
the holder in reverse order.

Replace the pull-off lip if neces-
sary
:
If both edges are worn after turning
the silicone squeegee around, a
new silicone squeegee is required.
Replace silicone squeegee as de-
scribed above.

Adjust the dosing of cleaning solu-
tion.

Empty the dirt water reservoir (max.
100 ml content).
Finish up your work / clean
appliance
Storing the Appliance
Troubleshooting
Spray bottle does not spray
Machine does not start
Streaks while cleaning
Water is leaking from the side
of the tank
13 EN