Kärcher WD 4 Car, Manual

Page: 13 / 158

– 8
Illustration
 Connect the handle with the suction hose until it
snaps in place.
Illustration
 To remove the handle from the suction hose, press
the notch using your thumb and pull off the handle.
Note: Due to removing the handle, accessories can be
directly attached to the suction hose.
See position 12.
Recommendation: In order to vacuum the floor, attach
the handle to the suction hose.
Illustration
 Put both suction tubes together and connect them
with the handle.
 When vacuuming dry dirt off the floor, clip an insert
with two brush strips into the floor nozzle.
 When vacuuming water off the floor, clip an insert
with two rubber lips into the floor nozzle.
 For cleaning areas that are difficult to access, e.g.
between car seats.
 For quick and easy vehicle cleaning - from the foot-
well to the trunk.
 For thoroughly cleaning upholstery and carpet sur-
faces in the car. In desiccated dirt can be easily re-
moved with the sturdy bristles.
 For gentle cleaning of sensitive surfaces such as
car dashboard or center console.
ATTENTION
Always work with an inserted flat fold filter - during wet
as well as dry vacuum cleaning!
Illustration
 Release and remove the appliance head.
 Turn the container, press in the steering roller in the
openings at the base of the container till the end-
point.
 Insert and lock the appliance head.
Illustration
 Connect accessories.
Illustration
 Plug in the mains plug.
Illustration
 Turn on the machine.
ATTENTION
Work with a dry flat fold filter only.
Check the filter for damage prior to installation and re-
place as necessary.
Illustration
 Recommendation : To vacuum fine dust, use the
filter bag.
– The filling level of the filter bag depends on the dirt
that is sucked in.
– The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
– Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a pre-filter.
Order no. basic design: 2.863-139.0, premium design:
2.863-161.0.
ATTENTION
Do not use a filter bag!
 For vacuuming up moisture or wetness pay atten-
tion to the correct floor nozzle insert and connect
the corresponding accessories.
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Illustration
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
 Turn off the appliance and disconnect the mains
plug.
Illustration
 Remove the appliance head and empty the reser-
voir filled with wet or dry dirt.
Illustration
 Store the accessories and the mains cable on the
appliance and store the appliance in dry rooms.
Removable handle
Suction tubes 2 x 0.5 m
Floor nozzle
(with inserts)
Crevice nozzle, 350 mm
Car vacuuming tool
Suction brush with hard bristles, white
Suction brush with soft bristles, black
Operation
Before Startup
Start up
Dry vacuum cleaning
Information filter bag
Wet vacuum cleaning
Interrupting operation
Finish operation
Empty the container
Storing the appliance
13 EN