English
9
Illustrations on fold-out page!
These operating instructions de-
scribe the basic models of the
Multi-Purpose Vacs shown on the front cover.
Depending on the model, there are differences in
the equipment and included accessories.
When unpacking the product, make sure that no ac-
cessories are missing and that none of the package
contents have been damaged. If you detect any
transport damages please contact your dealer.
1
Container
2
ON/OFF switch
3
Suction hose connection
4
Storage compartment for mains cable
5
Carrying handle
6
Appliance head with clip closure
7
Storage for suction tubes and accessories
8
Power cord with plug
9
Swivel casters
10 Suction hose
11 Suction tubes 2 x 0.5 m
12 Floor nozzle with hard surface insert
13 Crevice nozzle
14 Filter bag
15 Cartridge filter or foam filter (already installed
in the device)
몇
Always work with an inserted cartridge or
foam filter - during wet as well as dry vac-
uum cleaning!
Illustration
Remove the appliance head and take acces-
sories out of the container.
Illustration
Fit the swivel casters on the container bottom.
Insert filter bag if required.
Illustration
Put the appliance head onto the container and
lock it.
Illustration
Connect accessories.
Illustration
Connect the mains plug and turn on the appli-
ance.
몇
Work only with a dry cartridge or foam fil-
ter filter!
For appliances with foam filter
: When dry
vacuuming, always install the filter bag in ad-
dition to the foam filter.
For appliances with cartridge filter
: To vac-
uum fine dust, use the filter bag.
The filling level of the filter bag depends on
the dirt that is sucked in.
The filter bag needs to be replaced more fre-
quently while sucking in fine dust, sand, etc.
Clogged filter bags can burst - therefore make
sure to replace the filter bag in a timely man-
ner!
Caution
: Always use a pre-separator while
vacuuming ashes and soot (order no. 2.863-
139).
Vacuum cleaning of hard surfaces:
Illustration
Insert the hard surface inlay into the floor nozzle.
The bristles should point towards the front.
Vacuum cleaning of carpets:
Illustration
Work without the hard surface insert.
Illustration
Use the hard-surface insert when wet vacu-
uming.
몇
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam forms
or liquids escape!
Note:
If the container is full a float closes the suc-
tion opening and the appliance works at a higher
speed. Switch off the appliance immediately and
empty the container
.
Illustration
Turn off the appliance and disconnect the
mains plug.
Illustration
Remove the appliance head and empty the
reservoir.
Description of the Appliance
Commissioning and operation
Attaching the Accessories
Dry vacuum cleaning
Wet vacuum cleaning
Finish operation
Empty the container
