– 3
Adjust the turning handle "power" as
per the surface to be cleaned
Adapt the slide controller Hoovercraft
effect to the ground.
Caution
Illustration
Do not run over protruding corners!
Fasten the T-Racer directly to the high-
pressure gun.
1 Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Caution
Illustration
Always hold the T-Racer at the handle
while cleaning the walls.
Adjust the turning handle "power" as
per the surface to be cleaned
Slide the slide controller Hoovercraft ef-
fect all the way to the right.
The turning handle "power" is used to
change the distance of the high-pressure
nozzles to the surface to be cleaned.
Robust surfaces
(for e.g. tiles, concrete,
stone)
Illustration
Set turning handle "power" to "MAX".
For the effective cleaning of hard-to-re-
move contamination.
Sensitive surfaces
(for e.g. wood)
Illustration
Set turning handle "power" to "MIN".
For the gentle cleaning of sensitive sur-
faces.
Use the slide controller to open and close
the ventilation slots in the T-Racer casing.
This regulates the Hoovercraft effect.
Illustration
Move the slide controller to the right.
The Hoovercraft effect decreases until
the T-Racer touches the floor.
Illustration
Move the slide controller to the left.
The Hoovercraft effect increases until
the T-Racer hovers above the floor.
You can use the extension pipes with any
other Kärcher accessory.
High-pressure cleaner does not build up
the pressure or is vibrating
.
Dismantle the high-pressure nozzles,
check the high-pressure nozzles for
damage, rinse the T-Racer with clean
water then reinstall the high-pressure
nozzles.
Cleaning wall surfaces
Control elements
"Power" turning handle
Slide controller Hoovercraft effect
Tip
Troubleshooting
9
EN
