– 2
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
See page 2, illustration
1 Casing
2 Slide controller Hoovercraft effect - air-
flow controller
3 Handle
4 Turning handle "power" (to adjust the
height of the nozzles)
5 Bayonet connection with safety cover
6 Extension tubes (two tubes)
7 Rotor arm
8 Safety clip
9 Protective grid
10 Yellow high-pressure nozzles (2 piec-
es)
11 Grey high-pressure nozzles (2 pieces)
12 Aperture for ventilation slots
You need to use the matching high-pres-
sure nozzles to ensure that your high-pres-
sure cleaner works properly.
Note:
Nominal pressure (p): See Operating
Instructions or type plate of your high-pres-
sure cleaner.
e.g.: K 6 – K 7, Kärcher 600 – Kärcher 770
Use yellow high-pressure nozzles.
Note:
The yellow high-pressure nozzles
have already been installed.
e.g.: K 4 – K 5, Kärcher 201 – Kärcher 560
Use grey high-pressure nozzles.
Illustration
1 Loosen the safety clamp with a screw-
driver.
2 Remove the protective grid.
3 Change the high pressure nozzles.
4 Mount the protective grid on the pin.
5 Push the safety clamp in until it locks.
Note
: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
Illustration
1 Screw the two extension pipes togeth-
er.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
Prior to use on sensitive surfaces (e.g.
wooden surfaces), test the product on
an imperceptible spot, in order to
promptly detect any changes in the sur-
face.
The T-Racer is not suited for scouring
or scrubbing!
Description of the Appliance
Preparing the Appliance
Selecting the high-pressure noz-
zles
High-pressure cleaner with nominal
pressure (p) of 13 MPa (130 bar) to 16
MPa (160 bar)
High-pressure cleaner with nominal
voltage (p) lesser than 13 MPa (130 bar)
Changing the high-pressure noz-
zles
a Remove the clip.
b Pull out the yellow high-pressure noz-
zle.
c Insert the grey high-pressure nozzle.
d Re-insert the clip.
Application
Cleaning floor surfaces
Tips for cleaning
8
EN
