6
English
Note
: Always use Kärcher water filter (order no.
4.730-097.0) during suction operations of the
high-pressure cleaner.
Fasten the T-Racer to the high-pressure gun us-
ing the extension pipe.
Î
Figure 2
1
Press the extension tube into the bayonet
connection of the high-pressure gun, then
turn by 90° until it locks into place.
2
Tighten the safety cover.
Repeat this process even for the other joints.
Î
Figure 3
몇
Caution
Do not run over free-standing corners!
The T-Racer is not suited for scouring or
scrubbing!
Outdoor surfaces should be swept before
the T-Racer is used to avoid damaging the
high-pressure nozzles.
Fasten the T-Racer directly to the high-pressure
gun.
1
Press the bayonet connection of the T-Racer
into the connection of the high-pressure gun,
then turn by 90° until it locks into place.
2
Tighten the safety cover.
Î
Figure 4
Caution
Always hold the high-pressure gun with both
the hands while cleaning the walls.
High-pressure cleaner does not build up the
pressure or is vibrating
.
Î
Dismantle the high-pressure nozzles, check
the high-pressure nozzles for damage, rinse
the T-Racer with clean water then reinstall
the high-pressure nozzles.
Î
Figure 5
1
Remove the clip.
2
Pull out the high-pressure nozzle.
3
Rinse the high-pressure nozzle with clean
water, replace if necessary.
4
Insert the nozzle.
5
Re-insert the clip.
You can use the spray pipe extension with
any other Kärcher accessory.
Use a moist cloth and clean the appliance after
use.
The appliance is maintenance-free.
Only use original Kärcher spare parts. You will
find a list of spare parts at the end of this docu-
ment.
Application
Cleaning floor surfaces
Cleaning wall surfaces
Troubleshooting
Cleaning the high-pressure nozzle
General notes
Tip
Maintenance and care
Care
Maintenance
Spare Parts
