Kärcher SGG 1, Manual, Page: 17 / 208

– 5
 Slide the detergent hose as far as pos-
sible into the detergent tank and screw
the special cover tight.
 Pull out the valve tube.
 If necessary, turn both gas valves on
the valve tube clockwise to close off the
gas supply.
 Check the seals on the valve tube for
signs of damage and replace if neces-
sary (see Care and Service).
 Screw the gas cartridges hand-tight
clockwise onto the valve tube and insert
them into the casing.
 Turn both gas valves on the valve tube
anticlockwise to switch on the gas sup-
ply.
 Fit the device cover and engage the
latches. Take care to ensure that no
hoses are kinked or jammed.
 Screw the brush onto the nozzle on the
lance.
 Put appliance on your back.
Illustration
 Latch the closure and adjust the hip
belt.
Illustration
 Adjust the appliance to your body by
pulling on the middle tensioners. Do not
pull too tight, the main load should be
on the hip belt.
Illustration
 Adjust the position of the appliance on
your back by pulling on the end tension-
ers.
Illustration
 Engage the lock and adjust the chest
strap.
 Connect the plug on the control unit to
the socket on the device and screw the
union nut tight.
 Press the battery charge level test but-
ton on the control unit. The charging
state of the battery is displayed.
 No LED lights up: Charge the battery
(see Initial startup)
Note: A black warning symbol appears on
the red label on the exhaust manifold on the
lance when the exhaust manifold is hot.
The symbol disappears again when the ex-
haust manifold has cooled down.
Note: The device may only be switched on
when carried on the back as described.
 Set the detergent supply controller to 0.
 Switch on the device at the on/off switch
and wait for 5 seconds.
 Press the ignition button.
The ignition process is audible.
 Set the detergent supply controller to 10
and wait until detergent escapes from
the nozzle on the lance.
 Set the detergent supply controller to 0
and wait for 1 minute until the boiler has
heated up.
 Set the detergent supply controller to a
value between 1 and 10 depending on
the surface and the area to be cleaned
(recommended: 2-3).
Note: The detergent filling level warning
lights up when the detergent tank is empty.
Carrying frame - adjust the hip belt,
shoulder straps and chest strap
Connect the control unit
Operation
Check the charging state of the
battery
Turning on the Appliance
17 EN