Kärcher RC 3.000, Manual

Page: 23 / 399

– 9
 Connect the mains plug to a suitable
socket.
Illustration
 Set up the station in the room to be
cleaned, e.g. as shown in the illustra-
tion.
Note : The appliance can be adjusted to
changing room sizes by means of se-
lecting the cleaning duration (see Chap-
ter “Selecting the Cleaning Duration”).
Illustration
 Select the site to set up the station so
that the cleaning robot is able to reach
several rooms.
Note : Adjust the required cleaning du-
ration (see Chapter "Select cleaning
duration").
Note : The cleaning robot normally passes
thresholds between rooms between 2 cm
and 8 cm down but not up.
 Observe the cleaning robot during the
initial cleaning process. Obstacles in
the room that cannot be overcome by
the appliance, should be removed
ahead of time. This will avoid undesired
interruptions.
 Clean up the room just like you would if
you were vacuuming prior to using the
cleaning robot. Do not leave loose ob-
jects on the floor.
 Tie up cables, strings, and curtains to
prevent the robot from pulling them
down.
 If you store the appliance for more than
4 months, please make sure that the
batteries are charged completely.
 If you let the cleaning robot work while
you are on the phone or watching TV,
activate the "Quiet mode" on the sta-
tion.
Cleaning a single room
Cleaning a complete floor
Caution:
For galleries and steps, the interior cor-
ners must be protected, in case the drive-
through height under the railing is higher
than 10 cm.
Operation
Preparation for cleaning
Caution:
Prior to using the cleaning robot, please
make sure that there are no obstacles,
such as on steps or thresholds.
Obstacles can be, for example:
– Newspapers, books, magazines, pa-
per
– Clothes, toys, CDs
– Plastic bags
– Bottles, glasses
– Curtains hanging down on the floor
– Bathroom mats
The following objects are, for example,
not considered obstacles:
– Single cables in the room
– Thresholds up to 1 cm high
– Carpet fringes that are shorter than 10
cm
Tips and Tricks
23 EN