– 4
If the wastewater container is full,
switch off the appliance. In order to do
so, set the rotary switch to 0/OFF.
Unlock the bonnet, swivel it upwards
and snap it in place at the locking devic-
es.
Remove the wastewater container from
the appliance and drain it.
Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
Shortly activate the lever on bender to
decrease the pressure.
Separate bender from the spray/suction
hose.
Remove the lid of the fresh water tank.
Insert the suction hose into the fresh
water reservoir.
Set rotary switch to vacuuming. Suction
turbine is switched on.
Empty the fresh water reservoir and
switch the appliance off.
Empty the wastewater reservoir.
Connect the manifold (with suction pipe
and nozzle) to the suction hose.
Connect the coupling of the spray hose
with the manifold and snap in place.
Fill approx. 2 litres of fresh water into
the fresh water reservoir.
Do not add any detergents.
Set rotary switch to spraying. Spray
pump is switched on.
Hold floor nozzle over a drain.
Activate lever on bender and flush the
appliance for appr. 1 to 2 minutes.
Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
Flush appliance.
Dismantle the bonnet, unlock and re-
move the filter casing. Clean the bonnet
under running water.
Empty the wastewater container and
clean it under running water.
Empty the fresh water reservoir.
Clean the outside of the appliance with
a damp cloth.
Remove all water from the appliance
prior to longer periods of non-use to
avoid offensive odours.
Allow appliance to dry thoroughly: Un-
lock the bonnet, swivel it upwards and
snap it in place at the locking devices.
Remove the lid of the fresh water tank.
Illustration
Place the floor nozzle in the tray and
snap the suction pipe into the holder.
Store the suction hose and the mains
cable as shown in the illustration.
Place the appliance in a dry room and
secure it from unauthorized use.
Spray and suction off detergent solution
in one work cycle.
Note:
Repeated suctioning without spray-
ing will shorten the drying time.
Apply detergent solution with suction
turbine turned off and soak for 10 to 15
minutes.
Clean the surface just like with normal
soiling.
In order to further improve the cleaning
result, the surface can be recleaned us-
ing clear, warm water.
Empty wastewater container
Empty the fresh water reservoir
Flush appliance
After each operation
Storing the Appliance
Cleaning methods
Normal soiling
Strong soiling or stains
16
EN
