English
5
Definition of abbreviations used
:
HP = High pressure
DT = Detergent
When unpacking the product, make sure that
no accessories are missing and that none of
the package contents have been damaged. If
you detect any transport damages please
contact your dealer.
Illustrations on Page 2
1
ON/OFF switch for appliance
2
Power cable with plug
3
HP outlet
4
HP hose
5
Trigger gun with safety catch
6
Connection for water supply with filter
7
Coupling element for water connection
8
DT tank
9
DT suction hose with filter
10 DT metering regulator
11 Accessory mount, spray lance
12 Accessory mount, HP hose
13 Accessory mount, trigger gun
14 Transport handle
15 Spray lance with pressure regulation
(Vario Power)
16 Spray lance with dirt blaster
When the appliance is delivered, the HP hose
and trigger gun are not attached, this pre-
vents buckling. Please mount these before
using the appliance for the first time.
Î
Push out the safety clip in the trigger gun
using e.g. a small screwdriver.
Î
Join HP hose and trigger gun together.
Î
Push clip in until it engages and check that
it is securely fastened by pulling on the HP
hose.
Î
Remove cable tie and unroll HP hose
For connection values, see type plate/techni-
cal data.
Observe regulations of water supplier.
Î
Use a fibre-reinforced hose (not included)
with a standard coupling: - Minimum diam-
eter, 1/2 inches (13 mm). - Minimum
length, 7.5 m.
Î
Screw the coupling unit (supplied) to the
water connection on the appliance.
Î
Push the water supply hose onto the cou-
pling unit, then connect it to the tap.
몇
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the HP pump.
If the water supply is not clean, the Kärcher
water filter must be used (special accessory -
order No. 4.730-059).
The appliance is not suited for use in
the drinking water supply network. It
is necessary to install a suitable sys-
tem separator from Kärcher, if the
device is to be used in the drinking water sup-
ply network.
When fitted with the appropriate accessories,
this high-pressure cleaner can draw in surface
water, e.g. from water butts or ponds (max.
suction height 0.5 m).
Î
Use the Kärcher water filter to protect the
HP pump and accessories (special acces-
sories, order no. 4.730-059). This filter re-
moves dirt from incoming water.
Commissioning and operation
Description of the Appliance
Initial start-up
Water supply
Water supply from mains
Drawing in water from open reservoirs