English
11
Illustrations on Page 2
When unpacking the product, make sure that no
accessories are missing and that none of the pack-
age contents have been damaged. If you detect
any transport damages please contact your dealer.
1
Coupling element for water connection
2
Connection for water supply with filter
3
High pressure connection
4
Appliance switch "0/OFF“/ „I/ON“
5
Display main power operation:
6
Display battery operation / charge status
7
Carrying handle
8
Battery
9
Battery compartment
10 Storage for spray lance
11 Cable clamp for mains connection cable
12 Storage for mains connection cable
13 Mains cable with mains plug
14 Trigger gun
15 Clamp for high pressure hose
16 Lock trigger gun
17 High pressure hose
18 Charger
19 Suction hose
20 Spray lance with dirt blaster
21 Spray lance with pressure regulation (Vario
Power)
Special accessories expand the possibilities of
using your appliance. Please contact your
KÄRCHER dealer for further information.
Mount loose parts delivered with appliance prior
to start-up.
Illustrations on Page 2
Illustration
Î
Pull out the clamp for the high-pressure hose
from the trigger gun (e.g. a small screwdriver).
Illustration
Î
Connect high pressure hose to trigger gun.
Î
Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.
Illustration
Î
Insert the battery into the battery compartment.
Note:
The battery is partially charged at the time
of delivery. Charge it before appliance startup
and then as and when required. Please follow
the instructions of the battery charger.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA.
Note:
Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Î
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Î
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Î
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Caution
Never operate the high-pressure cleaner when
the tap is turned off as dry running will damage
the high-pressure pump.
Î
Screw the suction hose into the water con-
nection and insert it into the water source
(e.g. rainwater drum).
Î
Separate the high pressure hose from the
high pressure connection of the appliance.
Î
Switch the appliance on "I/ON" and operate
until the water exits the high-pressure con-
nection without bubbles.
Î
Turn off the appliance "0/OFF".
Operation
Description of the Appliance
Special accessories
Before Startup
Water supply
Water supply from mains
Drawing in water from open reservoirs
Summary of Contents for K HC 10
Page 2: ...2 ...
Page 167: ...167 ...