![background image](http://html1.mh-extra.com/html/karcher/k-7-pure-home/k-7-pure-home_manual_655631012.webp)
– 7
ATTENTION
Dry running of more than 2 minutes leads to damage of
the high-pressure pump. If the appliance does not build
up pressure within 2 minutes, switch the appliance off
and proceed in accordance with the instructions in
Chapter "Troubleshooting".
ATTENTION
Risk of damage! The appliance must only be oper-
ated laying down (horizontal).
몇
CAUTION
Keep a distance of at least 30 cm when using the jet for
cleaning painted surfaces to avoid damage.
ATTENTION
Car tyres, paint or sensitive surfaces such as wood
should not be cleaned with the dirt blaster, as there is a
risk of damage.
Illustration
Push the spray lance into the trigger gun and fasten
it by a 90° rotation.
Turn on the appliance “I/ON”.
Unlock the lever of the trigger gun.
Pull on the lever of the trigger gun; the device will
switch on.
Note:
Release the lever of the trigger gun; the de-
vice will switch off again. High pressure remains in
the system.
Note:
Detergent can only be added when the device is
operated in low pressure mode.
DANGER
When using detergents, the material data safety sheet
issued by the detergent manufacturer must be adhered
to, especially the instructions regarding personal pro-
tective equipment.
Illustration
Pull detergent suction hose as far as is required out
of the housing.
Suspend end of detergent suction hose in a con-
tainer filled with detergent.
Use spray lance with pressure regulation (Vario
Power).
Turn the spray lance as far as it will go in the direc-
tion of "SOFT".
Note:
This will mix the detergent with the water
stream.
Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
Spray off loosened dirt with the high pressure jet.
Release the lever of the trigger gun.
Lock the lever of the trigger gun.
During longer breaks (more than 5 minutes), also
turn the appliance off using the "0/OFF" switch.
몇
CAUTION
Only separate the high-pressure hose from the trigger
gun or the device when there is no pressure in the sys-
tem.
After operation with detergent: Run the machine for
approximately 1 minute for a clear rinse.
Release the lever of the trigger gun.
Turn off the appliance "0/OFF".
Disconnect the mains plug from the socket.
Turn off tap.
Press the lever of the trigger gun to release any re-
maining pressure in the system.
Lock the lever of the trigger gun.
몇
CAUTION
When disconnecting the supply or high pressure hose,
hot water may leak from the connections after opera-
tion.
Detach the appliance from the water supply.
몇
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
Illustration
Lift appliance by the carrying handles and carry it.
Illustration
Pull out the transport handle until it audibly snaps
into place.
Pull the appliance by its transport handle.
Secure the appliance against shifting and tipping
over.
몇
CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing it.
Park the machine on an even surface.
Push the disconnect button on the trigger gun and
pull the high-pressure hose out of the trigger gun.
Push the casing of the quick coupling for the high
pressure hose toward the rear and disconnect the
high pressure hose from the appliance.
Illustration
Place the trigger gun into the storage for the trigger
gun.
Engage the spray lance in its holder.
Stow away the mains cable and the high-pressure
hose on the appliance.
Operation
High pressure operation
Operation with detergent
Recommended cleaning method
Interrupting operation
Finish operation
Transport
When transporting by hand
When transporting in vehicles
Storage
Storing the Appliance
12
EN