background image

10 

English

ATTENTION

Dry running of more than 2 minutes leads to damage of 
the high-pressure pump. If the appliance does not build 
up pressure within 2 minutes, switch the appliance off 
and proceed in accordance with the instructions in 
Chapter "Troubleshooting".

ATTENTION
Risk of damage! The appliance must only be oper-
ated laying down (horizontal).

CAUTION

Keep a distance of at least 30 cm when using the jet for 
cleaning painted surfaces to avoid damage.

ATTENTION

Car tyres, paint or sensitive surfaces such as wood 
should not be cleaned with the dirt blaster, as there is a 
risk of damage.

Illustration 
Push the spray lance into the trigger gun and fasten 
it by turning it through 90°.

Turn on the appliance “I/ON”.

Unlock the lever on the trigger gun.

Pull on the lever of the trigger gun; the device will 
switch on.

Note:

 Release the lever of the trigger gun; the de-

vice will switch off again. High pressure remains in 
the system.

Note:

 Detergent can only be added when the device is 

operated in low pressure mode.

DANGER

When using detergents, the material data safety sheet 
issued by the detergent manufacturer must be adhered 
to, especially the instructions regarding personal pro-
tective equipment.

Illustration 
Pull detergent suction hose as far as is required out 
of the housing.

Suspend end of detergent suction hose in a con-
tainer filled with detergent.

Use spray lance with pressure regulation (Vario 
Power).

Turn the spray lance to "Mix" position.

Note:

 This will mix the detergent with the water 

stream.

Spray the detergent sparingly on the dry surface 
and allow it to react, but not to dry.

Spray off loosened dirt with the high pressure jet.

Release the lever on the trigger gun.

Lock the lever on the trigger gun.

During longer breaks (more than 5 minutes), also 
turn the appliance off using the "0/OFF" switch.

CAUTION

Only separate the high-pressure hose from the hand 
spray gun or the appliance when there is no pressure in 
the system.

After operation with detergent: Run the machine for 
approximately 1 minute for a clear rinse.

Release the lever on the trigger gun.

Turn off the appliance "0/OFF".

Disconnect the mains plug from the socket.

Turn off tap.

Press the lever on the trigger gun to release any re-
maining pressure in the system.

Lock the lever on the trigger gun.

CAUTION

When disconnecting the supply or high pressure hose, 
hot water may leak from the connections after opera-
tion. 

Detach the appliance from the water supply.

CAUTION

Risk of personal injury or damage! 
Mind the weight of the appliance during transport.

ATTENTION

Do not carry the unit by its storage for high pressure 
hose and mains cable.

Illustration 
Lift appliance by the carrying handles and carry it.

Illustration 
Pull out the transport handle until it audibly snaps 
into place.
Pull the appliance by its transport handle.

Secure the appliance against shifting and tipping 
over.

CAUTION

Risk of personal injury or damage! 
Consider the weight of the appliance when storing it.

Park the machine on an even surface.

Press the disconnect on the trigger gun and re-
move the high pressure hose from the trigger gun.

Push the casing of the quick coupling for the high 
pressure hose toward the rear and disconnect the 
high pressure hose from the appliance.

Illustration 
Insert the trigger gun in its holder.
Engage the spray lance in its compartment.

Illustration 
Stow away the mains cable and the high-pressure 
hose on the appliance.

ATTENTION

Appliances and accessories that are not completely 
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.

To avoid damage:

Completely drain all water from the appliance: 
Switch the appliance on with detached high pres-
sure hose and detached water supply (max. 1 min-
ute) and wait, until no more water exits at the high 
pressure connection. Turn off the appliance.

Store the appliance and the entire accessories in a 
frost free room.

Prior to extended storage periods, as during the winter, 
also observe the instructions in the Care section.

Operation

High pressure operation

Operation with detergent

Recommended cleaning method

Interrupting operation

Finish operation

Transport

When transporting by hand

When transporting in vehicles

Storage

Storing the Appliance

Frost protection

Summary of Contents for K 4 Silent





























Reviews: