8
English
The scope of delivery of your appliance is illustrated on
the packaging. Check the contents of the appliance for
completeness when unpacking.
In the event of missing accessories or any transport
damage, please contact your dealer.
Fabric-reinforced water hose with commercially
available coupling.
–
Minimum diameter, 1/2 inches (13 mm).
–
Minimum length 7.5 m.
This high pressure cleaner is designed for domestic use
only.
–
for cleaning machines, vehicles, buildings, tools,
facades, terraces, gardening tools, etc. by means
of a high-pressure water jet (if necessary, with ad-
ditional cleaning agents).
–
with accessories, replacement parts and cleaning
agents approved by KÄRCHER. Please observe
the information accompanying the cleaning agents.
Notes about the ingredients (REACH)
You will find current information about the ingredients
at:
www.kaercher.com/REACH
Mount loose parts delivered with appliance prior to start-
up.
Illustrations on Page 13 and 14
Illustration
Push the wheels into the intake.
Secure the wheels using the included plug. Align
the plug properly!
Illustration
Place the bottom holder into the recesses and push
forward until it audibly locks in.
Insert the top holder and push down all the way.
Illustration
Press in the storage hook and lock it into the top po-
sition.
You will need the 2 included screws as well as a Phillips
screwdriver PH 2.
Illustration
Slide the transport handle into the guide and se-
cure it with 2 screws.
You will need the 2 included screws as well as a Phillips
screwdriver PH 2.
Illustration
Insert both detergent hoses onto the hose fittings.
Install the dosage regulator and connect using 2
screws.
Note
: During installation you must make sure that
the tongues of the dosage regulator match up with
the intended recesses in the casing.
Illustration
Slide the free end of the coiled high pressure hose
through the recesses on the dosage regulator.
Insert the hose drum into the intakes on the trans-
port handle.
Insert the axle of the hand crank into the guides.
Install the fixating plate and secure it using 2
screws.
Press the connecting fitting from the short high
pressure hose into the brass intake, secure with
clamps.
Note:
Make sure the connection nipple is aligned
correctly.
Illustration
Push the high pressure hose into the trigger gun
until it locks audibly.
Note:
Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
Scope of delivery
Additionally required
Proper use
Environmental protection
The packaging material can be recycled. Please
arrange for the environmentally appropriate dis-
posal of the packaging.
Old appliances contain valuable recyclable mate-
rials that should be recycled properly. Please ar-
range for the environmentally appropriate disposal
of the old devices.
Cleaning operations which produce oily waste wa-
ter, e.g. engine washes, underbody washes, may
only be carried out using washing stations
equipped with an oil separator.
Work with detergents must only be performed on
liquid-tight work surfaces with a connection to the
sewer system. Do not let release detergent into
waters or earth.
The extraction of water from public waters is pro-
hibited in some countries.
Assembly
Install wheels
Install the storage for trigger gun
Install the storage hook for the mains
connection cable
Install the transport handle
Install the dosage regulator for detergent
Install the high pressure hose drum
Connect the high pressure hose to the
trigger gun
