Kärcher K 3.190, Manual

Page: 16 / 232

– 8
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g.
from water butts or ponds (see specifica-
tions for max. suction height).
 Fill the KÄRCHER suction hose with
backflow valve with water, screw to wa-
ter supply and hang into the water butt.
 Remove air from appliance before oper-
ation.
Switch on the appliance without con-
nection the high-pressure hose (max. 2
minutes) and run it until the water dis-
charging from the high-pressure outlet
is free of bubbles. Switch off appliance
and reconnect high-pressure hose.
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
Illustration
 Insert the high pressure hose tightly into
the quick coupling on the appliance, it
will lock in audibly.
Note: Make sure the connection nipple
is aligned correctly.
 Check the secure connection by pulling
on the high pressure hose.
Illustration

Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Completely open the water tap.
 Insert the mains plug into the socket.
 Turn on the appliance “I/ON”.
몇
Danger
The handgun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the handgun and spray lance
firmly.
Illustration
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max". You
can add detergent when "Mix" is selected.
 Release the lever on the trigger gun.
Illustration

Turn the spray pipe to the desired posi-
tion.
For particularly dirty items or areas.
Caution
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
Not suitable for use with detergents.
Suitable for use with detergents.
Caution
Please make sure that the washing brush is
free from dirt or other particles. Otherwise,
it may damage the paint work.
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
Illustration
 Fill the detergent solution in the deter-
gent tank (observe dosage instructions
on the packaging of the detergent).
 Use spray lance with pressure regula-
tion (Vario Power).
Drawing in water from open reservoirs
Start up
Operation
Spray lance with pressure regulation
(Vario Power)
Spray lance with Dirtblaster
Washing brush
Working with detergent
16 EN