background image

6  

English

According to the applicable regula-
tions, the appliance must never be 
used on the drinking water net 
without a system separator. Use a 
suitable system separator manufactured by 
Kärcher; or, as an alternative, a system 
separator as per EN 12729 Type BA.

For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.

Î

Use a fibre-reinforced hose (not includ-
ed) with a standard coupling: 
- Minimum diameter, 1/2 inches (13 mm)
- Minimum length, 7.5 m.

Î

Screw the coupling unit (supplied) to 
the water connection on the appliance.

Î

Push the water supply hose onto the 
coupling unit, then connect it to the tap.

Caution

Never operate the high-pressure cleaner 
when the tap is turned off as dry running will 
damage the High pressure pump.
If the water supply is not clean, the Kärcher 
water filter must be used (special accesso-
ry - order No. 4.730-059).

Î

Screw high pressure hose on to high 
pressure outlet on appliance.

Î

Push the appropriate spray lance on to 
the trigger gun and fasten it by turning it 
to the right through 90°.

Î

Open tap.

Î

Plug in mains plug.

Î

Set main switch to “I/ON”.

Î

Press safety catch on the trigger gun to 
release it and pull lever.

Risk of injury

The trigger gun is subjected to a recoil force 
when the water jet is discharged. Make 
sure that you have a firm footing and are 
also holding the trigger gun and spray lance 
firmly.

 

Î

For normal cleaning tasks.

Operation with detergents not possible

Note:

Detergent can only be added when the ap-
pliance is being operated in low pressure 
mode.
All washing brushes supplied by Kärcher 
are designed for use with detergents.

Î

Detach spray lance from handgun. 

Note

A low-pressure jet is generated if 

the spray lance is not attached to the 
handgun. 

Î

Place the end of the Detergent suction 
hose in a container with Detergent solu-
tion.

1 Spray a small dose of the detergent on 

the dry surface, and allow it to react 
(make sure the detergent does not dry 
up).

2 Wash off the loosened dirt using the 

high-pressure jet.

To ensure a trouble-free operation of the 
appliance and to match the individual 
cleaning task, we recommend our Kärcher 
detergent and maintenance agents. Please 
ask for our advice, or request information 
on the products.

Commissioning and operation

Water supply

Water supply from mains

Start up

High pressure operation

Spray lance with High pressure nozzle

Operation with detergent

Detergent take-up from container

Recommended Cleaning Method

Detergents

Summary of Contents for K 2.19













Reviews: