English
7
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
Î
Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Î
Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
Î
Completely open the water tap.
Î
Insert the mains plug into the socket.
Î
Turn on the appliance “I/ON”.
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
Î
Unlock the lever on the trigger gun.
Î
Pull on the lever of the trigger gun; the
device will switch on.
Note:
Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
For normal cleaning tasks.
Not suitable for use with detergents.
For particularly dirty items or areas.
Not suitable for use with detergents.
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developped for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
Î
Detach spray lance from the trigger
gun. Work only with the trigger gun.
Î
Pull detergent suction hose as far as is
required out of the housing.
Î
Suspend end of detergent suction hose
in a container filled with detergent.
Î
Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
Î
Spray off loosened dirt with the high-
pressure jet.
Î
Release the lever on the trigger gun.
Î
Lock the lever on the trigger gun.
Î
During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
Î
Insert the trigger gun in its holder.
Caution
Only separate the high-pressure hose from
the trigger gun or the appliance while there
is no pressure in the system.
Î
After working with detergent, suspend
detergent suction hose in a container
filled with clear water, switch the appli-
ance on for around 1 minute once the
spray lance has been removed and
rinse until water runs clear.
Î
Release the lever on the trigger gun.
Î
Turn off the appliance "0/OFF".
Î
Turn off tap.
Î
Detach the appliance from the water
supply.
Î
Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
Î
Lock the lever on the trigger gun.
Î
Pull out the mains plug.
Î
Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.
Start up
Operation
Spray lance with high pressure nozzle
Spray lance with Dirtblaster
Working with detergent
Recommended cleaning method
Interrupting operation
Finish operation
