4
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running the
water for one minute into an empty“ 5-
gallon container.
Step 1
Pull out the locking slide from
the right side of the trigger
gun handle.
Step 2
Insert the small end of the
high pressure hose into place.
IMPORTANT PRECAUTIONS –
continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Step 3
Push the locking slide back into
the trigger gun to lock the hose
in position.
Step 5
Insert the Spray Wand Extension into
the trigger gun. Press in against the
spring tension and twist into the lock
position. Turn the Spray Wand
Extension Collar clockwise until tight.
Step 4
Connect the detergent suction
tube to the pressure washer.