Kärcher HDS 995 M/MX Eco, User Manual

Page: 15 / 21

30
English
Display
Necessary maintenance jobs
Î Remove the soot from the heating coil
(Customer Service)
Î Remove the calciul deposits from the
heating coil (Customer Service).
Î Clean/ replace ignition electrodes (Cus-
tomer Service).
Î Clean/ replace burner nozzle (Custom-
er Service).
Î Adjust burner (Customer Service)
Display
Necessary maintenance jobs
Î Check overflow valve of the pump for
leaks (Customer Service).
Î Check high-pressure hose (Customer
Service).
Î Clean hand-spray gun.
Î Check pressure accumulator (Custom-
er Service).
Figure 1 - Pos. 19
Î Take out sieve.
Î Clean sieve in water and reinstall.
Figure 10
Î Unpressurize the appliance.
Î Unscrew lid with filter.
Î Clean the filter with clean water or com-
pressed air.
Î Reinstall in reverse sequence.
Figure 11
Î Loosen covering nut and take off hose.
Figure 12
Î Take out sieve.
Note
If necessary turn in screw M8 appr. 5 mm
inwards and therewith pull out sieve.
Î Clean sieve in water.
Î Push sieve inwards.
Î Put on hose.
Î Tighten covering nut firmly.
Figure 13
Î Take out detergent suck supports.
Î Clean filter in water and reinstall.
Figure 14
Î Ready a catch bin for appr. 1 Liter oil.
Î loosen release screw.
Î Tighten release screw.
Î Fill oil slowly up to the MAX marking.
Note
Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.
Figure 2 - Pos. 7
This indicator lamp blinks if there is a mal-
function.
Î Rectify the fault.
Î Turn on the appliance again. Indicator
lamp goes off.
Display
Troubleshotting
Î Increase water flow quantity.
Î Clean the sieve in the water connection.
Clean the sieve in the water connection
Cleaning the fine filter
Clean sieve in the water shortage safe
guard
Clean filter at the detergent suck hose
Oil change.
Dispose of old oil ecologically or turn in at
a gathering point.
Faults
Indicator lamp: Engine/ Electronics
is blinking