Kärcher HDS 655 M Eco, Instructions Manual

Page: 29 / 36

English
29
n
Warning
Only use original spare parts.
After each work, turn off device, refer to "Af-
ter each operation".
! Set the appliance switch to "0".
! Disconnect the main plug from the
socket.
!
Shut off water supply.
!
Activate hand spray gun until device is
pressure less.
! Remove water connection.
! Allow device to cool down.
Your Kärcher vender will inform you
about the performance of a periodic
safety inspection resp. signing of a
maintenance contract.
! Clean the sieve in the water connection.
! Clean the fine filter.
! Check oil level.
In case of lacteous oil inform Kärcher
customer service immediately
! Clean sieve in the water shortage safe
guard.
!
Clean filter at the detergent suck hose.
! Oil change.
Figure 1 - Pos. 18
!
Take out sieve.
!
Clean sieve in water and reinstall.
Figure 10
! Unpressurize the appliance.
! Unscrew lid with filter.
! Clean the filter with clean water or com-
pressed air.
! Reinstall in reverse sequence.
Figure 11
! Loosen covering nut and take off hose.
Figure 12
! Take out sieve.
Note
If necessary turn in screw M8 appr. 5 mm
inwards and therewith pull out sieve.
! Clean sieve in water.
! Push sieve inwards.
! Put on hose.
! Tighten covering nut firmly.
Figure 13
! Take out detergent suck supports.
! Clean filter in water and reinstall.
Figure 14
! Ready a catch bin for appr. 1 Liter oil.
! loosen release screw.
! Tighten release screw.
! Fill oil slowly up to the MAX marking.
Note
Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.
Figure 2 - Pos. 3
– Fuel tank empty
! Refill.
Figure 2 - Pos. 6
– Engine overload/overheat
! Turn device switch on "0" and let engine
cool off for min. 5 minutes.
Maintenance intervals
Weekly
Monthly
After 500 operating hours, at least annu-
ally.
Maintenance Works
Clean the sieve in the water connection
Cleaning the fine filter
Clean sieve in the water shortage safe
guard
Clean filter at the detergent suck hose
Oil change.
Dispose of old oil ecologically or turn in at
a gathering point.
Troubleshooting
Fuel indicator lamp glows
Indicator lamp "Ready for use"
turns off