background image

English

Operating Instructions HD 10/25 S/SX Plus, 13/18 S/SX Plus

19

Interrupting the operation

„

Release lever of the handgun, the unit 
switches off. Retract lever again and the 
unit switches on again.

Availability time

Within the availability time, the unit starts 
when the hand-held spray gun is opened. 
The indicator light will go green.

If the spray gun remains closed for 
30 minutes, the availability time ends. 
The indicator light will flash green.

Reset availability time

„

Switch off the unit switch.

„

Wait a moment.

„

Switch the unit back on again. 

Customer Service can change the unit to 
permanent operation.

Switching the unit off

„

Set unit switch to "0" and pull out power 
plug.

„

Close water inlet.

„

Retract lever until the unit is without pres-
sure.

„

Push safety catch of the hand-held spray 
gun forward to lock the lever of the gun 
from being actuated inadvertently.

Danger!
Risk of scalding due to hot water. Re-

sidual water contained in the switched off unit 
can heat up. When removing the hose from 
the water inlet, the heater water can spurt out 
and cause scalds. Do not remove the hose 
until the unit has cooled down.

Transporting the cleaner

„

To transport the cleaner over relatively long 
stretches, take hold of it by the handle and 
pull it along behind you.

„

Empty the detergent reservoir before trans-
porting it horizontally.

Storing the cleaner

„

Place the handgun in the support.

„

Reel in the high-pressure hose and hang it 
over the hose rest.

or

„

Wind the high-pressure hose on to the 
hose reel. Push in the crank handle to lock 
the hose drum.

„

Coil the connecting cable round the cable/
hose rest.

Frost protection

Caution!
Frost will destroy a unit that is not com-

pletely empty of water! Store the unit where it 
will be free of frost.

If storage away from frost is not possible:

„

Empty the detergent tank (see care and 
maintenance/As and when required).

„

Drain off the water and rinse the unit 
through with anti-freeze.

„

Leave the unit to dry for max. 1 minute.

„

Use the standard glycol-based anti-freezes 
for cars.

„

Follow the handling instructions of the anti-
freeze manufacturer.

Care and maintenance

Danger!
Before any care and maintenance work 

on the unit draw out the mains plug.

Caution!
When changing the oil, dispose of any 

waste oil only at authorised collection points.

Safety inspection/Maintenance 
contract

You can arrange with your dealer to have a 
regular safety inspection carried out or to 
have a maintenance contract. Please seek 
advice.

!

!

Summary of Contents for HD 10/25 S VEX

















Reviews: