#9.800-085.0 • Rev. 01/08
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
6
STEP 1:
Attach handle to the frame
of the pressure washer.
Note
: It
may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
STEP 2:
Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STEP 3:
Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
STEP 4:
Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 7:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 8:
Connect the high pres-
sure hose to the pump discharge
nipple. Push coupler collar forward
until secure.
STEP 5:
Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 6:
Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
STEP 9:
Connect garden hose to
the cold water source.
ASSEMbLy INSTRUCTIONS
STEP 10:
Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
frame
Assy.
Carriage
bolt
Nut
Studs
Nut
Hose/gun
Storage
bracket
Safety
Latch
Spray
gun
High
Pressure Hose
Nozzle Extension
Spray
gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand Coupler
Wand
Collar
Pump
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
garden
Hose
Pump
Water Inlet
garden Hose
Coupler Collar
bolts
