![background image](http://html2.mh-extra.com/html/karcher/dg-232437/dg-232437_operation-manual_3667830007.webp)
9.800-082.0 • 15751000-1100 • Rev. 04/09
7
PRESSURE WASHER
OPERATOR’S MANUAL
STEP 1: Attach the handle to the
frame of the pressure washer.
Note
: It may be necessary to move
the handle supports from side to
side in order to align the handle so it
will slide over the frame supports.
STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STEP 3:
Attach the spray gun/hose
storage handle and bracket to
handle. Tighten nuts.
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 7:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 8: Connect the high pres-
sure hose to the pump discharge
nipple. Push coupler collar forward
until secure.
STEP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 6: Pull the spring-loaded col-
lar of the wand coupler back to insert
your choice of pressure nozzle.
STEP 9:
Connect (7.5m) garden
hose to the cold water source.
ASSEMbLy INSTRUCTIONS
STEP 10: Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
frame
Assy.
Carriage
bolt
Nut
Studs
Nut
Hose/Gun
Storage
bracket
Safety
Latch
Spray
Gun
High
Pressure Hose
Nozzle Extension
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Pump
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
bolts
Summary of Contents for DG-232437
Page 2: ......