Kärcher CV 66/2, Service Manual

Page: 6 / 18

6
English
Î
Restore cable connections. Contact arrangement:
Î
Bundle the cables with the harness
Î
Reinstall the cover
Î
Check the function and make sure that the switch was in-
stalled in the correct position.
Î
Remove the cover (see "Disassembly of operating panel")
Î
Carefully open cable tie (cut)
Î
Disconnect the connectors on the wire harness
Î
Remove the operating from the handle by removing 4 screws
from the side
Î
Take the operating panel off toward the front and pull out the
wire harness through the side boring. Do not damage the
plug!
Î
Remove the handle and the handlebars (see "Removing the
handle")
Î
Pull the wire harness out of the column
Î
Disconnect the connectors in the appliance
Î
Route a new wire harness
Î
Restore the connections
Î
Reassemble the handle and the operating panel
The handle must be removed in order to be able to remove the
appliance hood. The handle can be adjusted via a shaft and
locks. This adjustment must be dismounted in the shown se-
quence to prevent damage.
Î
Remove the plastic cover from the right side (side without ad-
justment lever).
Î
Unscrew the screw from the shaft and remove the column in-
cluding the lock.
Î
Pull the shaft out of the left side. The adjustment lever and the
shaft are connected via a joint. The connection is secured by
a splint. The plastic cap can only be removed if this splint and
the connecting piece are removed.
5.5 Replace wire harness
5.6 Removing the handle