English
3
Detergent tank
1
Tank cap
2
Detergent Tank
Installation
Mounting the push rod
1. Align the holes in the push rod with the holes in the device.
1
Thrust rod
2
Screw
3
Device
2. Screw in and tighten the 4 screws with 20 Nm.
3. Insert the plug into the coupling.
1
Casing half
2
Plug
3
Socket
4. Insert the two halves of the housing into one another so that
the connection is protected against spray water.
Initial startup
Fitting the pad
Note
Please select the correct accessory for your cleaning task.
●
Brush for Structured floors
●
Pad for Smooth floors
1. Disconnect the mains plug from the socket.
2. Pull the lever for level adjustment.
3. Swivel the handle to the front into a vertical position.
4. Release the lever for level adjustment.
5. Tilt the appliance rearward.
6. Place the disc brush/driver plate onto the actuator and turn in
counterclockwise direction.
Fill the detergent tank
몇
WARNING
Unsuitable detergents
Health risk, damage to the device
Use only recommended detergents. The operator carries all in-
creased risks relating to operational safety and increased risk of
accidents if using other detergents.
Use only detergents free of solvents, salt and hydrofluoric acid.
Adhere to the safety instructions stated on the detergent packag-
ing.
ATTENTION
Risk of damage
A cleaning solution with a temperature above 50°C can damage
the device.
Only fill the detergent tank with a cleaning solution up to a maxi-
mum temperature of 50°C.
1. Open the detergent tank.
2. Fill the detergent solution into the detergent tank.
3. Close the detergent tank.
Operation
Adjusting the handle
몇
WARNING
Danger of accident
The device can perform uncontrolled movements if the handle is
adjusted while the motor is running.
Only adjust the handle when the device is switched off.
1. Pull the tilt adjustment lever up and hold it in position.
2. Bring the handle into a comfortable position (about waist
height).
3. Release the tilt adjustment lever.
4. Move the handle up and down slightly until it latches into
place.
