Operating instructions
ICC 1 S B/D
English
35
Clean suction orifice with Kärcher
high-pressure cleaner
Danger!
After it has been turned off the
suction turbine runs-out for a few
seconds.
Open the maintenance flap only
30 sec. after switching off or stop of
the suction turbine.
Note:
The suction turbine is automatically
stopped and braked if the debris
container is raised or the seat flap is
opened while the suction turbine is
switched on.
Clean fan conduit under the seat
with Kärcher high-pressure
cleaner
Detach the radiator grille
Note
The cooler may not be cleaned
unless the engine is switched off.
The cooler is to be cleaned
outwards from the inside with
compressed air or a low-pressure
water jet.
It is not to be cleaned with a high-
pressure cleaner.
Do not use any aggressive cleaning
agents!
Unscrew engine cover
Allow water in the fan casing to
drain off by opening the butterfly
valve
Note:
The machine must be cleaned daily
after the work is finished.
Maintenance intervals
Elapsed-time meter
When maintenance is due can be
seen at the "Engine" operating hour
counter.
Maintenance by the
customer
Daily maintenance
Check the engine oil level
Check the cooling water level
Check the tyre air pressure
Check side brushes and fan for
wear and tear and wound-up
bands
Clean radiator
Additional maintenance once a
week
Check the hydraulic oil level
Clean water filter (more often,
depending on water quality)
Additional maintenance every 100
hours/ once a year
Change the engine oil
Change engine oil filter cartridge
Lubricate front axle bearing
Lubricate the bearings of the side
broom lifter
Check fan belt and round belt for
wear and tear
Clean fuel filter (only
for ICC 1 S D), replace, if
necessary (ICC 1 S D/B)
Check fuel hose and clamp
Clean air filter
Check fouling indicator of
hydraulic filter
Additional maintenance every
200 hours/ every six months
Check the cooler hoses and
clamps
Note:
All service and maintenance work
must be carried out solely by a
qualified employee.
Consult Kärcher Service, if
necessary.
Maintenance by the
customer service
department
Maintenance after 20 operating
hours
First inspection
Maintenance operations every
400 operating hours/ every six
months
Maintenance operations every
1200 operating hours
Note:
To safeguard warranty rights, during
the warranty period all service and
maintenance work must be
performed by an authorised Kärcher
after sales service.
