– 8
Rinse the spray tubes in the appliance as follows:
Fill the detergent container with about 1 liter of
clear water.
Hold the nozzle above the drain, and switch on the
spraying pump until the clear water has been con-
sumed.
몇
CAUTION
Always work with the filter bag inserted, except when a
cartridge filter is used (optional accessory).
The reservoir and accessories must be dry to prevent
parts from sticking together.
Illustration
Insert a filter bag.
Illustration
Use the adapter for wet/dry vacuuming Attach the
adapter to the handle, turn the locking handle to se-
cure it.
Select the desired accessories and attach to the
spray/suction pipes or directly to the attachment.
Switch on suction (position I).
Illustration
Insert the hard surface inlay into the floor nozzle.
The bristles should point towards the front.
Illustration
Work without the hard surface insert.
Use the surrounding air separator to adapt the suc-
tion force.
Note:
Close the surrounding air separator again after
use!
몇
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam forms or liq-
uids escape!
Note:
If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Use washing nozzle to vacuum up wet dirt/water.
If you use a crevice nozzle:
Attach and secure the adapter for wet/dry vacuuming.
Install the crevice nozzle directly to the adapter.
Switch on suction (position I).
Illustration
Open the surrounding air separator if water is suc-
tioned from a tank. Close it again after use.
Empty the full reservoir (refer to chapter "Empty
reservoir").
Turn off the appliance.
Empty the full reservoir (refer to chapter "Empty
reservoir").
Rinse the reservoir thoroughly with clear water.
Separate the handle, the spray/suction hoses and
the wash nozzle from each other; open locking le-
ver to achieve this (centre position),
Flush the accessories separately under running
water and let air dry.
Clean the foam filter under running water; let it dry
before reinserting it.
Leave the appliance open to let it dry.
Storing the appliance
. Store the accessories on
the appliance and store in dry rooms.
DANGER
Turn off the appliance and remove the mains plug prior
to any care and maintenance work.
Repair works may only be performed by the authorised
customer service.
몇
WARNING
Do not use abrasives, glass or universal cleaners! Nev-
er immerse the appliance in water.
With an uneven spray jet.
Illustration
Loosen nozzle attachment and pull out, clean or re-
place spray nozzle.
1 x year or as needed.
Illustration
Turn the lock and loosen it. Take out the sieve and
rinse it with water.
Fill up fresh water reservoir.
Check the fresh water reservoir for correct fit.
Detergent pump defective, contact customer service.
Clean the spray nozzle of the washing nozzle.
Close the surrounding air separator at the handle.
See diagram 11
Accessories, suction hose or suction tubes are
clogged, please remove the obstruction.
Filter bag is full: Insert new filter bag.
Cleaning the foam filter.
Fill up fresh water reservoir.
Plug in the mains plug.
The overheat alarm has been triggered, please al-
low appliance to cool down.
Subject to technical modifications!
End wet cleaning process
Dry vacuum cleaning
Vacuuming hard surfaces
Vacuuming carpeted floors
Wet vacuum cleaning
Shutting down
Maintenance and Care
Clean the spray nozzle
Clean the sieve in the fresh water reservoir
Faults
No water exiting from nozzle
Spray stream uneven
Insufficient vacuum performance
Detergent pump noisy
Appliance is not running
Specifications
Voltage
1~ 50/60 Hz
220 - 240
V
Mains fuse (slow-blow)
10
A
Container capacity
18
l
Water intake, max.
4
l
Output P
nom
1200
W
Output P
max
1400
W
Power cord
H05-VV-F2x0,75
Sound pressure level
(EN 60704-2-1)
74
dB(A)
13
EN
