Step # 7
Slide dividers, with groove for back panel facing
the back of the unit, onto connecting cam pins on
top of the middle shelf. Once divider is tight
against middle shelf, tighten cam with a Phillips or
flat head screw driver, clockwise about 1/2 turn,
or until snug.
Step # 8
Take divider shelf and slide into notches on dividers. If shelf
is a little tight, please do not use a
hammer to hit into place, as this will mark up the edge of the shelf. If needed, use a rubber
mallet. Once divider shelf is in place, slide 3 back panels into the back panel grooves of the 3
middle divider sections.
Step # 9
Install 8 connecting cam pins into the plastic cam
inserts on the bottom of the top shelf, as in step
# 5. Place shelf, cam side down, on top of
dividers, and line up connecting cam pins with
holes on top of the dividers. This is the trickiest
part of assembling the whole unit, so take your
time, and do not rush. It may be a little tight, but
again, please do not use a hammer to hit shelf
into place. If necessary, use a rubber mallet.
Once shelf is tight against the dividers, tighten
cams clockwise with a Phillips or a flat head
screw driver, about 1/2 turn, or until snug.
