Kantech IoPass SA-500, Installation Manual

Page: 13 / 36

P r o g r a m m i n g I o P a s s ™ - I n t r o d u c t i o n - I o P a s s P r o g r a m m i n g M o d e
13
S e c t i o n 3 • P r o g r a m m i n g I o P a s s ™ - I n t r o d u c t i o n
3.1 IoPass Programming Mode
To enter the programming mode, you have to enter the 6-
digit Master Password followed by the [#] key. The default
Master Password is [111111].
The LCD will display the following information:
1. ENROLL 2. PASSWD
3. TIMER 4. SYSTEM
From these basic functions, more options are available.
When programming the unit, you need to know that:
• The
[*] key is used to either go back to the previous
menu, or delete what was entered.
• The [#] key is used to accept, save the data that was
modified or programmed in the system and quit.
3.2
IoPass Factory Defaults
The factory defaults consists of a series of options that are
automatically set up in the unit as the “basic” system
configuration and can be modified.
Description
Factory
Default
To
Modify
Access mode Card only (mode 0) See p. 17
Master password 111111 (always
enabled) See p. 17
Main password 1234 (always
enabled) See p. 18
Duress function Disabled See p. 23
Auxiliary function Disabled See p. 22
Auxiliary password 1234567 (default)
when enabled See p. 18
Guard function Disabled See p. 21
Guard password 123 (default)
when enabled See p. 18
Tamper alarm func-
tion Disabled See p. 23
Forced entry alarm
function Enabled See p. 24
Door ajar Enabled See p. 24
Alarm relay acti-
vated on door ajar Disabled See p. 24
Incorrect PIN keyed
in incorrectly five
times activates
alarm relay (P-ERR) Disabled See p. 25
Card auto-deletion
on PIN error (5
times) Disabled See p. 25
Beeper key tones Enabled See p. 26
Alarm relay activa-
tion timer when
door left open more
then the preset time
(door ajar) 30 seconds (has to
remain open more
than 30 seconds to
trigger alarm
relay—if the func-
tion is enabled) See p. 24
Duress relay active
time (Relay-1) 10 seconds (when
enabled) See p. 23
Auxiliary relay
active (Relay-1)
time 3 seconds Cannot be
modified
Guard relay active
time (Relay-1) Remains activated
until deactivated
manually Cannot be
modified
Alarm relay active
time 240 seconds
(4 min.) See p. 26
Strike relay active
time 10 seconds See p. 27
Exit button input
type Normally Open
(NO) See p. 26
Door contact type Normally Open
(NO) See p. 26
Description
Factory
Default
To
Modify