■
The machine is factory-set at C.
The V-shaped groove on outside eccentric
④
and inscription C on middle eccentric
⑥
are
aligned with mark X.
■
To change the standard position, follow the procedures below by referring to the
illustrations as seen from the machine pulley.
A.
To change from C (CENTER) to B (BACK)
1).
Loosen outside eccentric set screw
⑤
first. Align the V-shaped groove on
outside eccentric
④
with mark X by turning outside eccentric
④
and middle
eccentric
⑥
counterclockwise.
2).
Secure outside eccentric
④
by tightening outside eccentric set screw
⑤
.
Align inscription B on middle eccentric
⑥
with mark Y by turning only middle
eccentric
⑥
90
°
clockwise. Then tighten middle eccentric set screw
⑦
.
B.
To change from C (CENTER) to F (FRONT)
1).
Loosen outside eccentric set screw
⑤
first.
Align the V-shaped groove on outside eccentric
④
with mark Y by turning
outside eccentric
④
and middle eccentric
⑥
counterclockwise.
2).
Secure outside eccentric
④
by tightening outside eccentric set screw
⑤
.
Align inscription F on middle eccentric
⑥
with mark Y by turning only middle
eccentric
⑥
90
°
counterclockwise. Then tighten middle eccentric set screw
⑦
.
< Note >
Do not tighten excessively outside eccentric set screw
⑤
and middle eccentric set
screw
⑦
(torque them to 15kg
･
cm).
5
