KANSAI SPECIAL DFB1012P, Instruction

Page: 21 / 32

18
6666----2 Looper left 2 Looper left 2 Looper left 2 Looper left----to to to to----right movement right movement right movement right movement
When the looper passes the needle, the point of the
looper, moving to the right, should be 1.5mm
above the top of the needle's eye.
When the looper passes the needle, the point of the
looper, moving to the left, should be 3mm above
the top of the needle's eye.
■
For single chainstiching, when the looper enters
the needle thread loop, the point of the looper
should be 4mm above the top of the needle's eye.
■
To make this adjustment, remove the cover first,
loosen eccentric set screw D and then move
eccentric ball A.
6666----3 Looper setting dist 3 Looper setting dist 3 Looper setting dist 3 Looper setting distance ance ance ance
When the needle bar is at the bottom of its stroke,
set the distance from the point of the looper to the
center of the needle should be 3mm.
■
Adjustment is made by removing the cover and
loosening screw B on looper front-to-back lever A.