Remove the covering from the bottom ¼-
inch of the fin tab.
Coat the center of the stabilizer and the top
of fuselage with 30-minute epoxy.
Apply the epoxy to the bottom of the fin
front and rear.
Insert the fin into the stabilizer. Use a
straight edge at the rear of the fuselage to
insure a straight hinge line and a square for
perpendicular to the stabilizer. Wipe the
excess epoxy with a paper towel and alcohol,
and allow to cure.
Assemble the tail wheel as shown below. Be
sure the tiller arm is aligned with the tail
wheel.
Measure 1 ¼ inches forward from the rear
of the fuselage. Install the flying wire
bracket at this point.
Slide the tail wheel assembly back until it
6
