Kanga 5 Series, Operator'S Manual

Page: 43 / 78

Jaden Kanga Group
Jaden Kanga – OPERATORS MANUAL Page
43
TRACKS INSTALLATION
NOTE: Rear tyres are water filled for extra rigidity.
DISASSEMBLY
6. Place machine on level of hard surface
7. Chock track on opposite side to be worked on
8. Turn off machine, remove key and affix Danger Tag to key
9. Jack up one side of the Kanga Loader with a hydraulic car jack
10. Deflate tyres to approx. 70 kPa ( 10 PSI )
11. Unscrew all wheel nuts except one on the rear wheel
12. Remove front wheel together with the tracks first and then the back wheel
13. Remove wheels from tracks
INSTALLATION OF TRACKS
1. Jack up one side of the Kanga Loader with a hydraulic car jack, rated at a minimum of 1,500
kilograms
2. Place packing beneath machine to support machine in the event of jack failure
3. Stand up tracks with both wheels inside it next to loader (Fig. 1)
Note: Fit tracks with correct rotation as shown in Fig. 1, do not reverse rotation
4. Use Track Fitting tool to spread the two wheels apart until the distance between wheel centres
matches the axle distance of the machine Rotate wheel hubs to align stud pattern of wheels
5. Lift complete unit onto wheel hubs (Fig. 2) making sure that the front wheel is held on.
6. Remove Track Fitting Tool and push front wheel on fully.
7. Fit and tighten the wheel nuts
8. Inflate tyres to 450 kPa ( 65 PSI )
9. Repeat steps 1 - 8 on other side
Ensure filler nozzles are on the outside
Track fitting
tool
pressure
plate on
rear tyre
Fig. 1
Fig. 2
Track fitting
tool pins
into holes in
the front
wheel hub