Rooster CW Transceiver Rev3
Page 15 of 26
22
nd
Nov 2023
Now you know the values read this section again and this time fit each inductor one by one.
To fit them you will need to bend the leads of each
inductor at 90 degrees
right
next to the body
as shown
here they will then fit correctly on the board.
Here are the inductors fitted to
the board.
Make sure yours are fitted
flush to the board and that the
leads are trimmed flush on the back of the board.
Stage 7: Front end bandpass filter
We now will fit the last two crystals, Y1 and Y2
These crystals will be the larger ones in the kit.
They are both the same and either can be fitted in either position.
When fitted the board
should look like this.
Not much more to do
now.
Summary of Contents for Bassinet
Page 22: ...Rooster CW Transceiver Rev3 Page 22 of 26 22nd Nov 2023 Circuit Diagrams...
Page 23: ...Rooster CW Transceiver Rev3 Page 23 of 26 22nd Nov 2023...
Page 24: ...Rooster CW Transceiver Rev3 Page 24 of 26 22nd Nov 2023...
Page 25: ...Rooster CW Transceiver Rev3 Page 25 of 26 22nd Nov 2023 Board Layout...