KanexPro SW-2X14KUSBC, Manual

Page: 20 / 25

SW-2X14KUSBC – 2x1 USB-C & HDMI Auto switcher
16
6.2.6
Third-party Device Control
Connect a third-party device (e.g. projector) to the RS232 port of switcher, the third-
party device can be controlled simultaneously by the below RS232 commands while
press the front panel button (ON, OFF, MUTE, or VOLUME -).
Command Function Command Example
#SET_ON_[B]_
[T]:XXXX
Send the command "XXXX" to the
third-party device while the
DISPLAY ON key is pressed.
⚫
The “[B]” represents the baud
rate of
third-party device.
[B]
Baud Rate
00 115200
01 57600
02 38400
03 19200
04 9600
05 4800
06 2400
⚫
The “
[T]
” represents the delay
time of sending command, and
its value is “00~99”.
⚫
The “XXXX” represents the
specific command (ASCII, up to
48 byte).
Command:
#SET_ON_05_30:1234567
Feedback:
@BAUDRATE: 4800
@DELAY TIME: 30 s
@DISPLAY ON TO
SEND:1234567
#SET_OF_[B]_
[T]:XXXX
Send the command "XXXX" to the
third-party device while the
DISPLAY OFF key is pressed.
⚫
The “[B]” represents the baud
rate of third-party device, and its
value is “00~06”, the
corresponding baud rate shows
at above list.
⚫
The “
[T]
” represents the delay
time of sending command, and
its value is “00~99”.
Command:
#SET_OF_05_30:ABCDEFG
Feedback:
@BAUDRATE: 4800
@DELAY TIME: 30 s
@DISPLAY OFF TO
SEND:ABCDEFG