7. ELECTROMAGNETIC
COMPATIBILITY
European Council Directive 89/336/EEC requires electronic equipment not to
generate electromagnetic disturbances exceeding defined levels and have adequate
immunity levels for normal operation. Specific standards applicable to this meter are
stated below.
As there are electrical products in use pre-dating this Directive, they may emit excess
electromagnetic radiation levels and, occasionally, it may be appropriate to check the
meter before use by:
Use the normal start up sequence in the location where the meter will be used.
Switch on all localized electrical equipment capable of causing interference.
Check all reading are as expected. A level of disturbance is acceptable.
If not acceptable, adjust the meter’s position to minimize interference or switch off, if
possible, the offending equipment during your test.
At the time of writing this manual (November 2011) Kane International Ltd are not
aware of any field based situation where such interference has occurred and this
advice is only given to satisfy the requirements of the Directive.
This product has been tested for
compliance with the following generic
standards:
EN 61000-6-3 : 2001
EN 61000-6-1 : 2001
and is certified to be compliant
Specification EC/EMC/KI/K455 details
the specific test configuration,
performance and conditions of use.
Please Note:
Batteries used in this instrument should be disposed of in accordance with current
legislation and local guidelines.
At the end of its life the meter should be sent to the appropriate recycling centre in
accordance with current legislation and local guidelines.