2
superglue! This will protect your fingers during
installation.
Remove the strap-knob, the nut, and 2 washers off
the endpin. Set the inner nut (this one is tight against
the terminal cap) to the required distance according
to the thickness of your end block. Finding the right
position may require some trial and error. Tighten
the terminal cap against the nut by screwing it in
clockwise.
Stick the 2 ft feeder wire into the endpin hole and
pull the other end out of one F hole. Make sure that
you leave a few inches of wire hanging out of the
endpin hole.
Tape Installation:
Peel of the brown tape off one
pickup and install it as practiced.
Superglue Installation:
Apply a generous amount of
superglue gel to one pickup. Spread the gel with the
tip of the tube over the entire golden surface.
Important:
If you use too little glue, it tends to
partially dry before you are able to bring the pickup
in its proper position! A generous amount of glue
will prevent premature drying.
Install the pickup as practiced and hold it tight in
position for about 30 seconds.
Tie the copper wire to the endpin jack at one of the
small 1/8” holes on its end. Pull the endpin jack out
of the endpin hole with the feeder wire. If the
distance of the inner nut was not set right, you have
to push the jack back through the F hole and do it
again. Carefully remove the feeder wire without
sliding the endpin jack back into the hole. Install the
endpin jack’s outer washers, nut, and strap knob.
Insert the feeder wire into the next F hole and pull it
out of the other one. Carefully tighten the second
pickup to the feeder wire and pull it out through the
other F hole. Install the second pickup the same way
as the first one.
Removing the Pickups
You can remove the pickups if they were installed
with the double-sided tape. Lift off an edge of the
pickup with a fingernail or a suitable tool and break
the bond. Once the pickups are pulled off, you can
rub off the glue residue with your thumb or use a
solvent like Naphtha to clean it (available in
hardware stores).
If the pickups were super-glued, removal is not
recommended. However, experienced luthiers
should be able to remove the pickups by cutting
them out with a special tool. Be aware that this will
most likely damage the pickups. It also is dangerous
to work with a cutting tool inside your guitar where
you can’t see what you are doing.
Please make sure you read and understand the
disclaimer below before you proceed with a
superglue installation or removal. Please call our
help line if you have any questions: (541) 888-3517
Disclaimer regarding the installation or removal of
the Pure Pickup:
Installation or removal is at your own risk. In no
event will K&K Sound Systems Inc. be liable to you
for any damages arising from your use of, or, the
inability to use this product. This includes any
possible health hazards, injuries, any lost profits, or
other incidental or consequential damages, even if
K&K Sound Systems Inc. has been advised of the
possibility of such damages, or for any claim by
another party. Exact following of mounting
instructions and handling instructions for supplied
superglue is mandatory.
Summary of Contents for Pure Archtop
Page 3: ...3...
