4
10. Install the new endpin jack:
Unscrew the endpin jack's strap mount knob. Take
off the nut and washer. Find out the thickness of
your end block and set the nut on the cap
accordingly (see picture below).
Once in place, screw the cap against it to secure the
nut. Insert the jack from the inside into the endpin
hole.
Tip:
A chopstick or something similar helps to get a
hold of the jack and pull it through the hole.
Attach outside washer and nut and tighten. Attach
the end knob.
Important:
Make sure that the strap knob screws in
ALL THE WAY over the outer threaded part of the
jack, so that a tiny portion of the thread is exposed
when the strap-knob is tightened.
If you don’t do this, you might experience
insufficient signal transmission and sound, which is
cutting in and out.
11. Secure the long wire from Pre-Phase’s circuit
board to the endpin jack with the provided self-
adhesive cable clamps.
