3
5. Stick the hard Velcro piece around the second
bottom brace in the lower bout of your guitar. Wrap
it around the brace length-wise (so that the long side
is going the same way as the brace).
TIP: The adhesive of the Velcro is very strong! If
you have an expensive guitar with soft wood
bracing, please tape a piece of masking tape
around the brace first and then the Velcro onto the
masking tape. This helps protecting the wood of
the brace if you would want to remove the Velcro
at a later date.
6. Now, both the
¼
” plug and the endpin jack should
have soft Velcro tabs wrapped around them.
7. Stick the two pieces of hard Velcro around the
second bottom brace in the lower bout of your
guitar. Wrap them around the brace length-wise (so
that the long side is going the same way as the
brace).
8. Plug the
¼
” plug into the pickup’s endpin-jack and
attach the connectors to the Velcro on the brace.
Make sure the cables of the pickup are looped free
in the air without touching anything in your guitar.
9. Attach the preamp circuit board and the battery
clip to their corresponding Velcro pieces.
