27
6 seconds ,until the device that keeps the flame lighted warms up.
On those models fitted with an ignitor (D)
, the "E" ignition button, identified by the
symbol, must first be pressed and then the corresponding knob pushed all the way in and
turned in the counter-clockwise direction to the "High" setting.
Some models are equipped with an ignition switch incorporated into the control knob. If this is the
case, the ignitor (
D
) is present, but not the "
E
" switch (the
symbol is located near each knob).
To light a burner, simply press the corresponding knob all the way in and, then, turn it in the
counter-clockwise direction to the High setting, keeping it pressed in until the burner lights.
Caution:
If the burner accidently goes out, turn off the gas with the control knob and try to
light it again after waiting at least 1 minute.
To turn off a burner
, turn the knob in the clockwise direction until it stops (it should be on
the "." setting)
Ceramic burner (Model 4Z-HEG22)
To turn on the ceramic burner:
Turn the knob in the clockwise direction.
To select a heating level:
The number around the outside of knob indicates the power level
that you have set the zone. Each cooking zone can be adjusted between 1 and 9, one being the
coolest zone setting and nine being the hottest zone setting.
To turn off a burner:
Turn the knob in the anti-clockwise direction until it stops (it should be
on the 0 position).
Residual heat indicator:
To the left of the control knob, there is one residual heat indicator.
To choose the right cookware:
Do not use cookware with jagged edges or a curved base.
Voltage: 220 - 240 V 50/60 Hz
Model: 4Z-HEG22 Max. Power: 3000W
3 HOW TO KEEP YOUR COOKTOP IN SHAPE
Before cleaning or performing maintenance on your appliance, disconnect it from the electrical
power supply.
To extend the life of the cooktop, it is absolutely indispensable that it be cleaned carefully
and thoroughly on a frequent basis, keeping in mind the following:
The enameled parts and the glass top, if present, must be washed with warm water
without using abrasive powders or corrosive substances which could ruin them
The removable parts of the burners should be washed frequently with warm water and
soap, making sure to remove caked-on substances
On cooktops with automatic ignition, the end of the electronic ignition device must be
cleaned carefully and frequently, making sure that the gas holes are not clogged
Stainless steel can be stained if it remains in contact with highly calcareous water or
aggressive detergents (containing phosphorous) for an extended period of time, it is
recommended that these parts be rinsed thoroughly with water and then dried well, It is
also a good idea to clean up any spills
Before using the ceramic glass module, the surface must be cleaned, using a damp cloth
to remove dust or food residues. The ceramic glass surface should be cleaned regularly
with a solution of warm water and a non-abrasive detergent, periodically, special products
will need to be used to clean the surface. First, remove all food buildup or grease with a
cleaning scraper, e.g.
