Installation guide
Kamstrup A/S • 55123402_A1_EN_12.2022
6
2G/4G Network Module • HC-003-80
2 The CALL function
1
Press and hold down the two outermost push buttons on
the calculator until the display shows “CALL”, and release
the buttons after 3 seconds.
2
After maximum 1 minute, the display must show “OK” in
the bottom left corner, indicating connection with READy
Manager.
You can use the meter’s display to read out the meter’s connection information. If the second digit in display menu 47 is 1 or
below, you must move the antenna to a better location. In some circumstances, it may be necessary to extend the cables and
to use an antenna with SMA connector as shown in Table 1 on page 7.
3 Accessing “TECH loop”
1
Press and hold the middle button down until the display
shows “1-User”.
2
Push the right arrow button until the display shows
“2-Tech” and confirm by pressing the middle button to
access “TECH loop”.
4 Accessing connection information
1
Press the buttons to access menu 2-101-03 and to read
out menu index 47.
2
Verify the data in the table below.
