5
Timer
1.96
with electronic room temperature control and room temperature sensor type 30076
Assembly and installation instructions
Modifications to the unit
Do not undertake any modifications, renovations or additions to the unit
without discussing these with the manufacturer as these could impair the
safety and operation of the unit. Modifications / alterations may only be
carried out with written approval.
Do not undertake any work on the unit that is not described in this
manual. On-site systems and cabling must be suitable for connection to
the intended system!
Connection faults or modifications can lead to damage to the unit! The
manufacturer shall not be liable for any damage due to the wrong
connection and/or improper handling!
2. Operation
This Kampmann time switch with electronic room temperature control is
used to control Kampmann heating units as a function of the room
temperature. The remote sensor detects the room temperature and
should it be below the temperature pre-set on the time switch, the
electronic controller within the time switch activates the stage switch.
When the pre-set temperature is reached, the system is switched off again.
The time switch can be programmed to operate in day or week mode and
heating and night set-back mode.
2.1 Wiring diagram - Unit heaters (e.g. TOP)
* Lay the 1.5 mm
²
connection cable for the sensor, e.g. J-Y (St) Y 4 x 2 x
0.8 mm, max. 100 m, separately from high-voltage cables.
** If there is a separate power supply for the timer then 3-core cable
including circuit breakers are required for the connection to the stage
switch.
Note:
only a stage switch may be connected to the timer with an
electronic room temperature control type 30076.
Sensor
Switch
to heating unit
Mains supply
stage switch
Mains supply ***
Time switch with electronic
room temperature control
Type 30076
Summary of Contents for 30076
Page 12: ......
