3
Item
Qty
Awning flysheet
1
Lateral AirPole
2
Groundsheet
1
Hand pump
1
Peg bag
1
Carry bag
1
If you are missing any parts please contact your supplying dealer.
Before using for the first time please check the contents of your awning
ATTACHMENT TO VEHICLE
The Travel Pod has a tunnel at the rear that can be attached to a vehicle—like
the side door of a camper van (VW style).
Keder Beading
The tunnel also has Keder beading sewn to its top edge. The beading can be
threaded into ‘figure of 8’ extrusion (not supplied) and the figure of 8 clipped to
the gutter on the side of the camper. Kampa Figure of 8 extrusion is available
from your supplying dealer.
Guy Line/Rope
If you camper does not have a gutter it is possible to pull the tunnel to the
vehicle by attaching guy lines/ropes (not supplied) to the top corners of the
tunnel, throwing these over the vehicle and tying them to the wheels or pegging
them down. Take care that the guy lines/ropes do not damage the vehicle.
Pole & Clamp Fixing (optional parts required)
This requires an optional pole and clamp set available from your dealer. The
pole is threaded through the sleeve in the top of the tunnel. This is then dropped
into the gutter on the side of the camper and secured using the clamps provided.
Using your roll out awning (if fitted)
The Keder beading can be slid into the channel found on the front of most roll
out awnings. It may be necessary to use a Drive-Away kit to convert the size of
the beading. Your dealer will be able to offer more advice.
4
2
3
IMPORTANT
It
is
important
that
whilst
unscrewing/replacing the inflation/
deflation valve that the valve does
not spin in the AirPole. You can
prevent this from happening by
holding the valve in place where it
meets the AirPole. In picture (2) the
left hand is holding the valve in
place. If the valve spins it will twist
the inflation tube in the pole and
may lead to premature failure. If
you suspect this has happened do
not inflate your awning before
untwisting the tube. Unscrew the
valve from the AirPole and check
that the inflation tube is not twisted.
Before replacing the valve ensure
that the black sealing washer is in
place (3).
WARNING
NEVER OPEN THE ZIP ON THE INNER TUBES WHILST THE
POLES ARE INFLATED. THIS WILL RESULT IN THE POLE
BURSTING.
Unroll and lay the awning out in the
required position (1). Peg each
corner of the awning ensuring that
you tension the awning between the
pegs and making sure that the
awning keeps it’s shape. You will
probably need to re-peg later.
1
SET UP
Unpack the awning and separate and identify the different parts.
